The Engineering Projects

I am searching for a way to make an H-Bridge as a motor controller. The Dual H-Bridge board offered is a good start for now. Is the schematic avaliable so that I can complete my analysis of the design? Next, the applicaiton is for a motor voltage of 150-200 VDC. The A4954 must be removed and other low voltage components and replace with devices that function at the higher voltage. Can standard MOSFETs be mounted on this board along with a heat sink? Are there pin compatable IGBT/MOSFET driver IC that will work up to 200 VDC? Are there other solutions that you may offer? Thanks.

JLCPCB – Prototype 10 PCBs for $2 (For Any Color)
China’s Largest PCB Prototype Enterprise, 600,000+ Customers & 10,000+ Online Orders Daily
How to Get PCB Cash Coupon from JLCPCB: https://bit.ly/2GMCH9w